ZTE ZXV10 W300

From SonicWiki
Revision as of 14:12, 31 December 2012 by Rodrigo (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

ZTE ZXV10 W300 configuration

Connect to web interface

The ZTE ZXV10 W300 ADSL/ADSL2 modem/routers shipped by Sonic.net act as NAT routers with DHCP by default. To access the internal web interface, take the following steps:

  • Connect the client computer directly to the W300
  • Configure the client computer to use
    • IP: 192.168.1.5
    • Subnet Mask: 255.255.255.0
    • Gateway: 192.168.1.1

The default administrative username and password are both "admin" (please change this to something known only to you).

ZTE ZXV10 W300 LEDs

ZTE ZXV10 W300 LEDs and definitions

Legend

  • Power indicates power
  • DSL indicates synchronization with the DSLAM
  • Ethernet indicates ethernet link
  • Internet indicates PPP connection


Static IP

  • Log into the modem's interface at 192.168.1.1
  • Enter the username and password for the modem interface.
  • Go to Interface Setup
  • Make sure that PVC1 is selected
  • Under ISP select Static IP
  • Enter First IP in static Bridged IP block as well as subnet and gateway.
  • Encapsulation: 1483 Bridged IP LLC
  • Bridge Interface: Activated
  • NAT: Enable
  • Default Route: Yes
  • Click Save
  • Click LAN
  • Change DNS Relay to "Use User Discovered DNS Server Only"
  • Enter 208.201.224.11 and 208.201.224.33
  • Click Save
  • Go to Maintenance then SysRestart
  • Make sure Current Settings is selected and click Restart.

Bridge Mode

Note: This is for turning off the routing behavior on the unit, not turning off PPPoE.

  • Log into the modem's interface at 192.168.1.1
  • Enter "admin" for username and password
  • Make sure that PVC1 is selected
  • Go to Interface Setup
  • Under ISP set "Bridge Mode"
  • Click Save
  • Click LAN
  • Change DHCP to "Disabled"
  • Click Save


Caveats

  • ZTE ZXV10 W300 ADSL modems act as a NAT router with DHCP when shipped.