Zyxel P-663HN-51

From SonicWiki
Jump to: navigation, search

Configuration

Connect to web interface

The Zyxel P-663HN-51 bonded ADSL2+ modems shipped by Sonic.net act as NAT routers with DHCP by default. To access the internal web interface, take the following steps:

  • Connect the client computer directly to the Zyxel
  • Configure the client computer to use
    • IP: 192.168.1.5
    • Subnet Mask: 255.255.255.0
    • Gateway: 192.168.1.1

This can typically be accomplished by allowing the client computer to acquire its IP information via DHCP.

By default, the administrative username is "admin" and the password is "1234" (please change this to something known only to yourself).

Configuring Static IP addresses

  • Log into the Zyxel P-663HN-51's interface.
  • From the summary screen click "Advanced Setup" in the left hand menu.
  • Click the "Edit" button that appears in the "Wide Area Network (WAN) Setup" screen.
  • Enter 0 for VPI, 35 for VCI. Set "Service Category" for "UBR Without PCR." Click "Next"
  • Select MAC Encapsulation Routing (MER) with an "Encapsulation Mode" of "LLC/SNAP-BRIDGING"
  • Click "Use the following IP address" and enter your static IP information in the "WAN IPv4 address" field, and your subnet mask into "WAN Subnet Mask" field. Check the "Use IPv4 Address" and "Use IPv4 Address" radio buttons, and enter in the gateway for your static IP. Click "Next."
  • NAT, Fullcone NAT, Firewall and Enable WAN Service are all checked by default. Make changes if necessary. Click "Next."
  • Verify settings are correct on this screen, then click "Next."
  • From the "Wide Area Network (WAN) Setup" screen click "Save/Reboot" Settings will be saved, modem will reboot.

Disabling UPnP/SSDP

  • Log into the Zyxel P-663HN-51's interface.
  • From the summary screen click "Advanced Setup" in the left hand menu.
  • Click "LAN" in the left hand menu.
  • Uncheck "Enable UPnP"
  • Click the "Save/Reboot" button at the bottom right.

LEDs

Zyxel P-663HN-51
Zyxel P-663HN-51 LED chart

Legend

  • Power indicates power
  • DSL1 and DSL2 indicate synchronization with the DSLAM
  • Ethernet indicates ethernet link
  • Internet indicates the device has an IP address

Caveats

  • Zyxel P-663HN-51 ADSL2 bonded modems act as NAT routers providing local addresses via DHCP when shipped.
  • Zyxel P-663HN-51 ADSL2 modems do not respond to ICMP echo requests by default.